Saltar al contenido principal

Sustitución de altavoz JBL Charge 3

Qué necesitas

  1. Sustitución de altavoz JBL Charge 3, Cubierta Frontal: paso 1, imagen 1 de 3 Sustitución de altavoz JBL Charge 3, Cubierta Frontal: paso 1, imagen 2 de 3 Sustitución de altavoz JBL Charge 3, Cubierta Frontal: paso 1, imagen 3 de 3
    • Voltea tu altavoz e inserta verticalmente la herramienta plástica en la abertura de la cubierta frontal.

    • Tira lentamente la herramienta plástica hacia afuera para quitar los cuatro clips que sujetan la cubierta en su lugar.

    • Repite este proceso para los cuatro bordes de la cubierta frontal

    Sometimes disassemblers forget that the first time they disassembled the item it didn’t want to give up easily: I didn’t like the forces I was having to apply at all, so I switched to two plastic prying tools per “corner” and one in-between them (total 5, you could use plectrums…) before I was happy the the forces were low enough not to break anything.

    Frank Puranik - Contestar

    the front grill is supposed to be first not the back the back has longer while the front has shorter clip

    Water Bass Tester (Water BT) - Contestar

    There are two Phillips head screws to remove before prying the cover off

    jason - Contestar

    Where in south Africa can I buy jbl charge3 port bay replacement

    Donovan Fransman - Contestar

    There appears to be different versions of the Charge 3. If you find it difficult to pry open a second side the two small screws mentioned by Jason will need to be removed but it also indicates that there will be some additional changes to this tear down that I will try to convey in the comments as well.

    john Ramirez - Contestar

    Sadly I damaged the latches on my charge 3. There was more to it than just prying the front cover up. First, there is a small latch on both sides that you need to push down before pulling the front cover towards you that release the clips holding the front cover in place. Pull only slightly forward because… Second, in the front cover there are 6 circular notches connected to the front cover in tue four corners including the middle corners, you need to squeeze the front cover a little bit gently removing the notches so they dont break (like mine did).

    ralphkeneth_gomz - Contestar

    Definitely had to watch about 10 videos and still couldn’t get it to pop out easily.. Took a look at the first picture in the next step and really took note of where the little hole that lets you through to push down the tab is. Once I took a look at that and combined the techniques I’d seen in some of the videos it finally popped off easily. https://www.youtube.com/watch?v=u7i0_nD9... I only watched the first minute of this video but it helped a good bit if anyone else is having trouble.

    Rowan Darko - Contestar

    How do you know if the speakers or one of them is burned or broken.. i notice that one speaker is playing much less hard then the other one.. I wonder now if maybe there is another problem with my device.. Battery problem?

    Bukowski101 - Contestar

  2. Sustitución de altavoz JBL Charge 3: paso 2, imagen 1 de 1
    • Separa la cubierta suavemente de ambos costados y quítela de la carcasa del altavoz.

    • El interior de la cubierta frontal tiene orificios que deben coincidir con sus pines correspondientes en la carcasa del altavoz para un armado adecuado.

    • Retirar la cubierta frontal no afecta los sellos impermeables del dispositivo. Sin embargo, cualquier desmontaje adicional de su altavoz requerirá quitar sellos y juntas impermeables. Es posible que tu dispositivo ya no sea impermeable después de que se haya modificado.

    Include dissembling the plastic cover? cover?

    KanGoon - Contestar

    @KanGoon Yes, on mine it took the removal of 6 (reasonably obvious) screws to remove that. I’ll try to insert a photo when I reassemble…

    Frank Puranik - Contestar

    Very good guide! Pics and descriptions make this easy!

    John G Petko - Contestar

    There is a step missing here. How do you remove the rubber cover that covers the port?

    Phillip Luebke - Contestar

    Gibt es eine Möglichkeit diese wieder wasserdicht zu bekommen?

    Furkan Karakelle - Contestar

    Well, broke off the cover tabs. Have to remove 2 screws first. Might add that to the instructions.🤔

    Spartacus - Contestar

  3. Sustitución de altavoz JBL Charge 3, Altavoz: paso 3, imagen 1 de 2 Sustitución de altavoz JBL Charge 3, Altavoz: paso 3, imagen 2 de 2
    • Retira los ocho tornillos de 10 mm Philips #1 alrededor de los dos altavoces frontales.

    Die Frage : Ist ob man irgendwo Ersatz Lautsprecher bekommt ???

    nicowihnaleck - Contestar

    Probier's mal hier, vergleiche aber ganz genau (Seriennummer GG…):

    https://ecommerce.mysav.eu/en/jbl/147-sp...

    VauWeh - Contestar

  4. Sustitución de altavoz JBL Charge 3: paso 4, imagen 1 de 1
    • Tira suavemente de uno de los altavoces para sacarlo de la carcasa. Ten cuidado ya que sigue conectado a la placa base.

  5. Sustitución de altavoz JBL Charge 3: paso 5, imagen 1 de 3 Sustitución de altavoz JBL Charge 3: paso 5, imagen 2 de 3 Sustitución de altavoz JBL Charge 3: paso 5, imagen 3 de 3
    • Con un destornillador Philips #000 presiona sobre la pestaña de metal que encontrarás en el conector del altavoz y tira suavemente para desconectarlo.

    Where can l buy those speaker for replacing

    Terrence Terrence - Contestar

    Somebody know where I can buy These speakers ?

    motje - Contestar

    The speakers that is on my charge 3 is soldered on doesn’t have the clips in picture

    travenature - Contestar

  6. Sustitución de altavoz JBL Charge 3: paso 6, imagen 1 de 1
    • Repite el paso anterior con el segundo conector.

  7. Sustitución de altavoz JBL Charge 3: paso 7, imagen 1 de 2 Sustitución de altavoz JBL Charge 3: paso 7, imagen 2 de 2
    • Con unas pinzas agarra el conector de cables empaquetado que une el altavoz con la placa base. Tira suavemente del conector para liberarlo.

  8. Sustitución de altavoz JBL Charge 3: paso 8, imagen 1 de 1
    • Una vez el segundo altavoz esté desconectado de la placa base, retira el altavoz y los cables de la carcasa.

    where can i buy these speaker,i need to replace the left side speaker because it was already damaged

    geoffrey mustar - Contestar

Conclusión

Para reensamblar tu dispositivo sigue las siguientes instrucciones de forma inversa.

42 personas más completaron esta guía.

Un agradecimiento especial a estos traductores:

en es

100%

¡ Hari Seldon nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›

Aidan Hays

Miembro Desde 10/08/18

3,815 Reputación

2 Guías creadas

Equipo

Cal Poly, Team S13-G1, White Fall 2018 Miembro de Cal Poly, Team S13-G1, White Fall 2018

CPSU-WHITE-F18S13G1

3 Miembros

26 Guías creadas

31 comentarios

Where I can buy the same jbl speaker ?

Ekinox - Contestar

I need to replace my JBL charge 3 speaker

Lara Esther -

Where can buy the small speakers? Helpp

Luis Cilia - Contestar

I have to pull out the motherboard to get those speakers out.

Tr0ll05aur0s 3z - Contestar

where can i buy the replacement speakers?

Yhamani Pangarungan - Contestar

Mine did not have the little clips in step 5. It was just soldered on. I ended up removing it from the other end. At the little white clip that goes in the motherboard (shown in step &) I was able to remove the pin. by pressing down on the top where you can see the silver.

Mike - Contestar

It doesn’t seem possible to buy replacement speaker units.

dave - Contestar

I see them on ebay, there are two designs. Btw, my speakers don't have clips, they are soldered on.

Erwin Johnson - Contestar

i just completed this repair using generic replacement speakers from ali express item number 32829635211

mine were soldered on. i had to trim 4 orientation posts that prevent the factory speakers being installed rotated incorrectly, as these wouldn’t work with the new speakers. they sound OK, but have noticeably less bass than the OEM JBL drivers and can sound a little more tinny. there are also people doing it on ebay for 30$, but i am not in the USA so that was not convenient.

ivan@absolutehid

ivan - Contestar

Where can I buy these same speakers

Silvester Whitehurst - Contestar

San mkabili ng orig.na speaker ng jbl3?

rodolfom.afan - Contestar

where I can buy these speakers. also need it for India region . but as I checked not able to buy it .

Prince Gupta - Contestar

Contact JBL customer service if y3have or gen get the teveipt call them and then email pic8or the receipt ant the JBL Serial number by the speakers when the blabk jbl grill is off if less than 12 months old youll get a free speaker replacement if out warranty or you have no receipt the replacement speaker for Charge3 is only $32.19 USD. Good luck.

David Lorince - Contestar

Contact JBL customer service if you have a charge 3. get the customer service number, call them and or then just email description fate SN# and pic of the receipt and the JBL Serial number between the speakers when the black JBL grill is off, but only if its less than 12 months old then you’ll get a free speaker replacement if out warranty or you have no receipt the replacement speaker for it is cheap only the JBL Charge3 is only $32.19 USD. Good luck.

David Lorince - Contestar

If you can find a cheap replacement battery for $20 grab it cause its totally worth it if out in the wilderness it also acts as a cellphone charger.

David Lorince - Contestar

Fyi upset neighbors since my left charge 3 is blown i decided it daisy chain 3 50 wayt pyle horn tweeters omg lets just day its about 500p% louder. Lol. Happy 4th of

David Lorince - Contestar

Do you have a specific link for this OEM JBL charge 3 speaker replacement or are you just directing us to the JBL company where they currently want $35 + shipping on a single speaker unless the Charge 4 and Flip 4 lower these crazy prices. Has any one found a similar Charge 3 speaker replacement that’s louder and cheaper ???

David Lorince - Contestar

For anyone that is wondering where to buy the speaker replacement, you can find it on all express just search up JBL charge 3 speaker replacement.

Armin Aghayan - Contestar

Absolutely ridiculous how much replacement speakers are! I found some that “work” but they sound like crap…… Considering I have 4 Charge3’s and 1 Charge4, Harmon already has PLENTY of my $$!

Sheldon Abbey - Contestar

JBL Charge 3 -

vorrei acquistare la coppia di casse uguale modello e dimensioni potreste fornirmi l’articolo a il link x ordinarli grazie

I would like to purchase the pair of speakers of the same model and size, could you provide me with the article at the link to order them, thank you

roberto - Contestar

Ciao @flipok ! Maybe you can find some options in this Answer on our Forum: Where to buy replacement speakers for JBL Charge 3? Good luck!

Claire Miesch -

In accurate info unless they change how they put it together later down the road

travenature - Contestar

good dayhouse pls where can i buy replacement speaker for jbl charge 3 and battery any body with information thanks

EMMANUEL JUNIOR - Contestar

I've ordered one. I will update after installation is done.

Rich Buffetta - Contestar

Simple install. Youll need a soldering iron, some solder and a smallish phillips. Works fine now for about 10 bucks from ali.

Rich Buffetta -

Amazon, JBL.Com, Ebay.. Search for OEM JBL Charge 3 replacement speaker. Very easy.

David Lorince - Contestar

Original speaker parts can be obtained in the UK by contacting Multicare Electronics ( +441132791255 , info@multicare.org.uk ). I initially called the Harman support line (Harman is the umbrella company of JBL), who redirected me to Multicare who are their official repair/parts company in the UK. Multicare sent me a replacement speaker unit for about £20 (ex shipping), which I have now fitted and is working perfectly. Good experience and thanks for this iFixit guide!

nixrushperseus - Contestar

I got my Charge 3 used, and apparently abused. Right speaker has pin holes in the cone; left speaker missing...

My question is why would anyone ground the + input to the speakers? Both are connected to the speaker inputs and also grounded to the speaker frame...

Thanks

Perry Thompson - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 29

Ultimos 7 días: 220

Ultimos 30 días: 935

Todo El Tiempo: 87,794