Insignia Flex 10.1 NS-P10W8100 Camera Replacement

Introducción

If your Insignia Flex 10.1 tablet (model NS-P10W8100) exhibits indications of a blurry lens, physical damage to the camera, or connectivity issues that prevent the camera from being recognized by the system, use this guide to replace the camera of your device.

A tablet’s camera is essential for capturing images and videos, supporting activities like photography, video conferencing, and document scanning. A malfunctioning camera may exhibit symptoms such as poor image quality (e.g., blurry or distorted visuals), failure to initialize, physical damage, or connectivity issues with the device’s system. This guide provides the steps to replace the malfunctioning camera, bringing the device’s imaging capabilities back to full functionality.

Before proceeding with the repair, disconnect the device’s battery from all power sources to avoid electrical damage. Use ESD-safe tools while replacing the camera to safeguard internal components from static discharge, and handle ribbon connectors gently to avoid causing any damage. Once the camera has been replaced, be sure to dispose of the old parts responsibly to minimize environmental damage. Use Earth911’s recycling directory for guidance on safe electronic waste disposal.

Before proceeding with the replacement guide, confirm that the device is completely powered down and disconnected from all external power sources.

Qué necesitas

Paso 1 Camera

Insignia Flex 10.1 NS-P10W8100 Camera Replacement, Camera: paso 1, imagen 1 de 2

Insignia Flex 10.1 NS-P10W8100 Camera Replacement, Camera: paso 1, imagen 2 de 2

Carefully open the laptop and remove the keyboard by disconnecting it.
Place keyboard to the side as you will not need it.
Beware of plastic clips on the side of the device.

Editar

Paso 2

Lay the screen flat on its surface and use the iFixit opening tool to remove the cover by gently prying the back cover from the screen.
Apply the opening tool to each side to help pry the back cover evenly.
Apply the opening tool to each side which will help pry the back cover evenly.
Do not pry on the bottom side of the device. This is the side across from the camera.

Editar

Paso 3

Use your fingers and pry the back cover from the screen. You may need to wiggle the cover a bit to separate the pieces.
If the back cover does not come off work your fingers around the corners and slowly pry the cover off using your fingers.
Be careful with potential sharp edges and any exposed electrical components.

Editar

Paso 4

Carefully remove the yellow tape holding down the camera ribbon connector by pulling it upwards.
Remove the black tape holding down the camera ribbon connector which is attached to the motherboard.

Editar

Paso 5

Disconnect the zero insertion force (ZIF) connector by using your fingernail to flip the small locking flap.
Disconnect the cable by gently pulling it outward.

Editar