Saltar al contenido principal

Introducción

Use this guide to replace the headphone jack in your Huawei P9 smartphone.

  1. First switch off your phone and remove the SIM card tray. Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port. If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.
    • First switch off your phone and remove the SIM card tray.

    • Unscrew the two Pentalobe P2 screws located at the bottom next to the device's USB C port.

    • If the screen is cracked you might want to use some tape to protect your eyes from glass shreds and get a better grip to open the phone.

  2. Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen. Use an iSclack or a suction handle to separate the phone assembly from the rear panel.
    • Avoid to lift only the display instead of the whole phone assembly as doing so may cause damage to the screen.

    • Use an iSclack or a suction handle to separate the phone assembly from the rear panel.

    • In case you can‘t manage to lift the phone assembly out of the rear panel you can insert the pointed end of a spudger in the headphone jack opening and press the phone assembly upwards until you create a gap between assembly and rear panel. Then use the spudger to lever the phone assembly out of the panel.

    • Don't remove the rear panel completely yet. There is a cable connected to it! It is running from the finger print sensor to the display unit.

  3. Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora

    Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora
  4. Disconnect the fingerprint sensor using a spudger. Disconnect the fingerprint sensor using a spudger.
    • Disconnect the fingerprint sensor using a spudger.

  5. Remove the water indicator on top of the screw. Undo the two Phillips #00 screws. Remove metal bracket (mind the adhesive underneath).
    • Remove the water indicator on top of the screw.

    • Undo the two Phillips #00 screws.

    • Remove metal bracket (mind the adhesive underneath).

  6. Disconnect the flex cable and remove the headphone jack. The old headphone jack is equipped with a rubber seal, which holds the jack down to the phone. Take it off and put it on the new headphone jack.
    • Disconnect the flex cable and remove the headphone jack.

    • The old headphone jack is equipped with a rubber seal, which holds the jack down to the phone. Take it off and put it on the new headphone jack.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Tobias Isakeit

Miembro Desde 31/03/14

55,805 Reputación

119 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

107 Miembros

9,430 Guías creadas

questo procedimento funziona anche con il modello p9 plus? grazie per l’attenzione

abcde181 - Contestar

Agregar Comentario

Ver Estadísticas:

Past 24 Hours: 4

Past 7 Days: 24

Past 30 Days: 122

Todo El Tiempo: 4,313