Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.
-
Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
-
Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove four 12 mm Phillips #1 head screws from the corners of the green gyroscope/motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the bottom left connector by squeezing it and pulling it away from the board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the white wires by squeezing the connector and pulling away from the board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug one set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the other set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.