Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #1 screwdriver, remove the two 14 mm screws closest to the center of the hoverboard.
-
Using a Phillips #1 screwdriver, remove the four 12 mm screws located in the middle of the panel.
-
Using a Phillips #1 screwdriver, remove the two 15 mm screws located closest to the wheel.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the bundle of wires from the clip on the top of the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #1 screwdriver, remove the four 14 mm screws that hold the battery on the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the battery out of the hoverboard by lifting the battery then sliding it out from under the wires.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.