Hover-1 Eagle Back Wheel Replacement

Introducción

This guide will walk you through how to replace a faulty or worn-down back wheel on a Hover-1 Eagle scooter. You should replace your back wheel if your back wheel has been worn down or damaged. To determine if you need to replace your back wheel, refer to our Troubleshooting Guide.

Qué necesitas

Paso 1 Back Wheel

Hover-1 Eagle Back Wheel Replacement, Back Wheel: paso 1, imagen 1 de 1

Peel off the reflective red axle sticker using a plastic spudger.

Editar

Paso 2

Use a Phillips #2 screwdriver to remove the 2mm screw located underneath the reflective sticker.

Editar

Paso 3

Hover-1 Eagle Back Wheel Replacement: paso 3, imagen 3 de 3

Grip the deck flare and slide it towards the tail end of the scooter.

Editar

Paso 4

Remove the 6 mm axle screws by using a hex bit 5.0.
Make sure to try loosening both sides. One of the axle screws spins freely and will not loosen.

Editar

Paso 5

Hover-1 Eagle Back Wheel Replacement: paso 5, imagen 3 de 3

Repeat Steps 1-3 for the other side.
Apply pressure to the axle using a hex bit 5.0 to push it slightly out on the other side.
Take hold of the 6 mm axle screw on the opposite side and remove the axle by pulling firmly towards you.