HP Deskjet D1660 Gear Guard Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

This guide will replace the gear guard, which will be hidden under the metal frame. It protects the gear from dirt and dust accumulation that would affect the printer's performance.

Qué necesitas

Paso 1 Top Cover

HP Deskjet D1660 Gear Guard Replacement, Top Cover: paso 1, imagen 1 de 1

Remove the back two 14.0 mm Torx #10 screws.

Traducir

Paso 2

Lay the printer on its back.
Grab the paper tray by its right side and pull it to the left and up.

Traducir

Paso 3

Open the frontal access panel by lifting it from the top.
Similar to the paper tray, grab it from the right side and pull it to the left and up.

Traducir

Paso 4

HP Deskjet D1660 Gear Guard Replacement: paso 4, imagen 3 de 3

Take out the two frontal 14.0 mm Torx #10 screws.
Carefully lift the frontal cover.
Don't lift it up aggressively. A strip will be attached to it.

Traducir

Paso 5 Ink Cartridge Rail

HP Deskjet D1660 Gear Guard Replacement, Ink Cartridge Rail: paso 5, imagen 1 de 2

HP Deskjet D1660 Gear Guard Replacement, Ink Cartridge Rail: paso 5, imagen 2 de 2

Remove the five 13.0 mm Torx #10 screws found on top of the frame.
Remove the four 9.0 mm Torx #10 smaller screws.

Traducir

Paso 6

Lift the rail carefully as a strip and motor will be connected to the bottom part of the printer.
Now detach the white strip and wires by gently lifting them up.

Traducir