Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lay the printer on its back.
-
Grab the paper tray by its right side and pull it to the left and up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the frontal access panel by lifting it from the top.
-
Similar to the paper tray, grab it from the right side and pull it to the left and up.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Take out the two frontal 14.0 mm Torx #10 screws.
-
Carefully lift the frontal cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five 13.0 mm Torx #10 screws found on top of the frame.
-
Remove the four 9.0 mm Torx #10 smaller screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Now detach the white strip and wires by gently lifting them up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The gear guard will be located on the left side of the printer.
-
Grab the plastic guard and lift it up.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.