Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
-
Mientras presiones el botón en el inferior de la GoPro, desliza la puerta de la batería a un lado para abrirla.
-
-
-
Tira de la lente y gira la cubierta hacia la derecha o hacia la izquierda hasta que se desprenda.
-
-
-
Consulta las instrucciones del iOpener para saber cómo calentarlo y usarlo.
-
Aplica el iOpener calentado en la parte delantera de la GoPro durante unos minutos, para derretir el adhesivo que hay bajo la placa frontal.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 3mm #000 Phillips screw.
-
Remove the 2mm #000 Phillips screw.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the tweezers to grasp the housing firmly and pull it away from the three ribbon cables.
-
Pull the battery housing until the half circle grooves on the back housing match up with the grooves on the battery housing.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
With your fingers, push from the inside of the battery compartment and pull the battery housing out from the back housing.
-
Cancelar: No complete esta guía.
10 personas más completaron esta guía.
Un comentario
Is there any glue to use to make the case waterproof again?