Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.
Introducción
This replacement is moderate in difficulty because it can be a bit tricky to get inside the side panels of the printer.
Qué necesitas
-
-
There are a few tabs on the top of the panel that hook down and into the black side panel. Insert the tool in-between the black panel and the blue panel as shown and pull the two pieces apart.
-
-
-
-
There is a tab you will have to push down to remove the part.
-
Once the tab is released the cover must be gently lifted away from the rest of the device to disengage the clips.
-
-
-
After unclipping all the hooks, pull off the black side panel to reveal the inner circuit boards.
-
-
-
There is a large white wire that leads to the USB chip. As you are pulling out the chip, detach the wire.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
4 personas más completaron esta guía.