Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the tabs on the top of the panel that hook down and into the black side panel.
-
Insert the Spudger in-between the black panel and the blue panel as shown and pull the two pieces apart.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws from the back right black panel using the Phillips #00 screwdriver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There is a tab you will have to push down to remove the part.
-
Once the tab is released, gently lift the cover away from the rest of the device to disengage the clips.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After unclipping all the hooks, pull off the black side panel to reveal the inner circuit boards.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws from the USB reader using the Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the large white ribbon cable that leads to the USB reader. As you are pulling out the USB reader, carefully detach the ribbon.
-
Cancelar: No complete esta guía.
4 personas más completaron esta guía.