Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
To take off the nozzle, filter, and catch bowl first start off by pushing in the button identified with a red square and twist that part of the device toward the handle portion of the vacuum and it should click and pop off the chassis.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the nozzle, filter and dust bowl have been removed each part can be removed from the nozzle section of the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you have successfully unscrewed the five screws holding the cover on you should be able to take the cover off.
-
Remove the L-shaped plastic hook.
-
Once the L shaped hook has been removed the motor will easily fall out of place.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the motor has been removed from its home the two wires that are giving it power can easily be removed by pulling on them carefully.
-
This will then allow for you to replace the motor.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three screws highlighted with red circles.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the battery by pulling it out of the slot it sits in.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To get to the charging port you will need the plastic opening tool.
-
Remove the three screws on the handle of the vacuum.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to separate the two pieces of plastic.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the plastic covering to the port.
-
Remove the wires to replace the charging port.
-