Saltar al contenido principal

Partes

No se especificaron partes.

  1. Unplug from all cables
    • Unplug from all cables

  2. unscrew two Phillips screws on each side of the BCD3000 If the screws sit too tight, you can use the extension for better torque
    • unscrew two Phillips screws on each side of the BCD3000

    • If the screws sit too tight, you can use the extension for better torque

  3. unscrew another two Phillips screws on each side unscrew another two Phillips screws on each side
    • unscrew another two Phillips screws on each side

  4. Lift the upper control part. Be careful, there are still some cables connected to the lower section. Disconnect the cables by walking them out of their sockets.
    • Lift the upper control part.

    • Be careful, there are still some cables connected to the lower section.

    • Disconnect the cables by walking them out of their sockets.

  5. Skip the upgrade.

    Descuento de $10 en tu factura de $50 con
    SKIPANDSAVE10

    Save Now

    Skip the upgrade.

    Take $10 off $50 with
    SKIPANDSAVE10

    Save Now
  6. Remove the upper part completely.
    • Remove the upper part completely.

  7. Disconnect the two cables from the lower section to the connector board.
    • Disconnect the two cables from the lower section to the connector board.

  8. Slide the lower section to the front. Now you can lift it and take it aside. Now you can lift it and take it aside.
    • Slide the lower section to the front.

    • Now you can lift it and take it aside.

  9. Disconnect the separate boards. Now you can take the modules out by unscrewing them from the case. Now you can take the modules out by unscrewing them from the case.
    • Disconnect the separate boards.

    • Now you can take the modules out by unscrewing them from the case.

  10. The jog wheels on the front panel can be taken off by using a spudger and levering them out. The jog wheels on the front panel can be taken off by using a spudger and levering them out.
    • The jog wheels on the front panel can be taken off by using a spudger and levering them out.

  11. The knobs can easy be removed just by pulling. The knobs can easy be removed just by pulling.
    • The knobs can easy be removed just by pulling.

  12. Same goes for the knobs on the top section of the front panel. Same goes for the knobs on the top section of the front panel. Same goes for the knobs on the top section of the front panel.
    • Same goes for the knobs on the top section of the front panel.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Tobias Isakeit

Miembro Desde 31/03/14

52,045 Reputación

116 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

100 Miembros

9,029 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 3

Últimos 30 Días: 21

Todo El Tiempo: 1,228