Saltar al contenido principal

Autosampler Configuration for Node Control (For Old & New Versions)

Qué necesitas

  1. Autosampler Configuration for Node Control  (For Old & New Versions), Starting the configuration process.: paso 1, imagen 1 de 3 Autosampler Configuration for Node Control  (For Old & New Versions), Starting the configuration process.: paso 1, imagen 2 de 3 Autosampler Configuration for Node Control  (For Old & New Versions), Starting the configuration process.: paso 1, imagen 3 de 3
    • 1. Turn on the autosampler. Screen will read "...STANDBY..."

    • 2. Press "ENTER/PROGRAM" button. Use arrows to highlight "CONFIGURE". Press "ENTER/PROGRAM" button

    • This will allow you to use the arrows to shuffle through the different configuration options. To select the one you want, press the "ENTER/PROGRAM" button.

    • 3. Use arrows to find "EVENT MARK". Press the "ENTER/PROGRAM" button.

  2. Autosampler Configuration for Node Control  (For Old & New Versions), Configuring "event mark".: paso 2, imagen 1 de 3 Autosampler Configuration for Node Control  (For Old & New Versions), Configuring "event mark".: paso 2, imagen 2 de 3 Autosampler Configuration for Node Control  (For Old & New Versions), Configuring "event mark".: paso 2, imagen 3 de 3
    • 4. Use arrow to select "CONTINUOUS SIGNAL". Press "ENTER/PROGRAM" button.

    • 5. Use arrow to select "PUMP CYCLE". Press "ENTER/PROGRAM" button.

    • It is critical this setting is configured in order for the sensor node to operate the autosampler!

    • 6. Use arrows to find "EXIT CONFIGURATION." Press "ENTER/PROGRAM" button. This will bring up the screen "...STANDBY...

Linea de Meta

Una persona más ha completado esta guía.

Brooke Mason

Miembro Desde 05/29/19

2,928 Reputación

17 Guías creadas

Equipo

Open-Storm Miembro de Open-Storm

Community

14 Miembros

24 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 5

Ultimos 30 días: 10

Todo El Tiempo: 97