Saltar al contenido principal

Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.

Qué necesitas

  1. Este paso está sin traducir. Ayuda a traducirlo

    : paso 1, imagen 1 de 3 : paso 1, imagen 2 de 3 : paso 1, imagen 3 de 3
    • Turn the controller over, exposing the three screws on the back. Use a 6mm screwdriver to remove these screws.

    • Carefully slide and pull the two parts of the controller shell apart, exposing the innards.

  2. Este paso está sin traducir. Ayuda a traducirlo

    : paso 2, imagen 1 de 1
    • Find the knobs (closest to the joystick and circled in red).

    • Locate the pots (closest to the circuitry and circled in orange). Keep track of these.

    • Align the joystick's metal bar into its cup.

    • Don't move any of the button circuitry, especially those of the START/PAUSE/RESET buttons.

  3. Este paso está sin traducir. Ayuda a traducirlo

    : paso 3, imagen 1 de 1
    • Use a spudger to remove the top frame.

    • Take off the plate.

    • Remove the rubber buttons.

  4. Este paso está sin traducir. Ayuda a traducirlo

    : paso 4, imagen 1 de 2 : paso 4, imagen 2 de 2
    • Realign the top and bottom of the controller.

    • Pull the circuit strip through the new space.

  5. Este paso está sin traducir. Ayuda a traducirlo

    : paso 5, imagen 1 de 3 : paso 5, imagen 2 de 3 : paso 5, imagen 3 de 3
    • Return the start buttons to the top of the controller

    • Snap the frame back into place

    • Screw in the three screws on the back.

Linea de Meta

4 personas más completaron esta guía.

Alan Abelson

Miembro Desde 09/26/14

233 Reputación

5 Guías creadas

Equipo

USF Tampa, Team 13-1, Staggers Fall 2014 Miembro de USF Tampa, Team 13-1, Staggers Fall 2014

USFT-STAGGERS-F14S13G1

5 Miembros

17 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 13

Ultimos 30 días: 34

Todo El Tiempo: 3,216