Saltar al contenido principal

Qué necesitas

Este desmontaje no es una guía de reparación. Para reparar tu Ascom d43 DECT phone, utiliza nuestros manuales de servicio .

  1. Ascom d43 DECT phone Teardown, Let's begin: paso 1, imagen 1 de 3 Ascom d43 DECT phone Teardown, Let's begin: paso 1, imagen 2 de 3 Ascom d43 DECT phone Teardown, Let's begin: paso 1, imagen 3 de 3
    • Place the phone in front of you.

    • Turn it around and start by removing the holding clip.

  2. Ascom d43 DECT phone Teardown, Removal of the battery and screws: paso 2, imagen 1 de 3 Ascom d43 DECT phone Teardown, Removal of the battery and screws: paso 2, imagen 2 de 3 Ascom d43 DECT phone Teardown, Removal of the battery and screws: paso 2, imagen 3 de 3
    • Slide down the battery cover

    • Remove the battery by pulling on the two cables (green rectangle)

    • Use a torx screwdriver to remove four screws (red circles).

  3. Ascom d43 DECT phone Teardown, The Insides: paso 3, imagen 1 de 3 Ascom d43 DECT phone Teardown, The Insides: paso 3, imagen 2 de 3 Ascom d43 DECT phone Teardown, The Insides: paso 3, imagen 3 de 3
    Herramienta utilizada en este paso:
    Tweezers
    $4.99
    Comprar
    • Pry open the phone from the side using a guitar pick or a spudger.

    • Be careful not to rip the two pieces apart because there are two connectors to be unplugged from the logic board (orange squares)

    • Use a pair of tweezers to accomplish this step and carefully remove the speaker as well as the headphone cable

    • Remove the two remaining torx screws that connect the logic board to the casing (red circles)

  4. Ascom d43 DECT phone Teardown, Speaker cable: paso 4, imagen 1 de 3 Ascom d43 DECT phone Teardown, Speaker cable: paso 4, imagen 2 de 3 Ascom d43 DECT phone Teardown, Speaker cable: paso 4, imagen 3 de 3
    • Use your tweezers to remove the remaining speaker cable on top

    • Then proceed to the ribbon cable for the display by rotating the phone by 90 degrees.

    • To remove the ribbon cable you must loosen the brown clip by gently pushing it up from both sides.

    • When the clip is loosened you may pull out the ribbon cable carefully.

    • Be sure not to damage the delicate cable with tools!

  5. Ascom d43 DECT phone Teardown, Done!: paso 5, imagen 1 de 1
    • There you have it. All serviceable parts have been disassembled. Well done!

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 7

Ultimos 30 días: 28

Todo El Tiempo: 526