c9679

You should always test the screen prior to fully fitting it… u dont know now if it was damaged on arrival or during ur fitting.

Lol I love these bend them the special way things lol When u say it stopped working how did it stop working was it dropped… how high was the drop Replace the screen put the metal plate back on with its screws dont mix up the screw order and it should be ok When it's working go slap the person who told u to bend it the special way in the face :) How did it stop working? Blank screen, fuzzy colours, no touch etc

The film that comes behind screens blue or red colour i use that for everything dab it in alcohol and slide under wiggle it about loosens adhesive, I even use it to remove iPhone 7 home buttons lol

U need to make sure the big grey chip is in the correct spot. Push the flex cables with the phone slightly open with the bottom of ur tweezers so the flex folds inwards… if the patch is down the middle vertically then it might be a swollen battery as it's an LCD refurbish it might also be the oca ur using or the glass being too thick etc, lots of different factors Make sure the rim of the housing is clean no lumpy left over adhesive and when u push the screen in push it upwards firmly first and then equally down on both sides working downwards, important part pushing it hard as u can into the top corners…

Screen looks cracked top right… replace the screen with another or try the original and see what u get… Definitely dont turn the cable around

You've split the screen in 2… look at the back of the glass uve removed part of the screen will probably still be in there hence the silver part of the screen showing. U will have to replace the complete screen.

Here u go iPad 5 LTE Front Panel Assembly Replacement

No however, u could upgrade the nand increasing storage space. Just remove the nand connect it to a programmer, read info, copy info to new nand with higher gig and put the nand back on :)

See how u go with the usual heating method on a hot plate, some oca and autoclave first its really boring work though lol Hot plate take glass off Oca remover make sure its heated correctly and blades are clean Place the oca Place the glass and put it into the press Finally autoclave the only nice stage All stages are extremely soul destroying lol

Long vertical = digitizer Short horizontal = LCD Short vertical = front camera Restart the phone or unplug the battery and plug it back in to try the replacement screen or after any changes… Try the old screen to rule out a problem with the part.