Lukas OKZ technician

turn it off. disconnect power cable reconnect press power on and hold - however long - until it switches off on its own press power again and hold till 2 beeps. release power button should see rocevery screen if not - update your ps to 4.xx firmware

connect to itunes, export your library through itunes, reinstall app, share library back onto device should be ready to go

upgrade your firmware on xbox with all acessories disconnected, pull hdd away , than test it - and let us know ;) good luck

most definately it needs REFLOW (if its fat model you good 99% of success, SLIM model 5% chance) 1. take it apart, clean any excess of grease, dust, dirt or old heatpaste leftovers 2, reflow (put your board in preheated oven at 210C with fan setting on for about 6-7 mins 3. let the board cool naturally, don't rush 4. reapply heatsink compound 1mm layer on both chips. 5. re-assemble should be 99% chances

try to heat it with heatgun on low setting

3 possibilities: 1.bad power supply, (either try to repair by locating wrong component and replacing it , or but new psu for your model) 2.blown capacitors (look for any odd loking fatten caps on the board , replace if need be) poor connection somewhere on the logic board. good luck

Update: Hi, it could be for following two reasons: from vibration during dropping : 1.your ps3 laser inside bluray drive could have gone out of sync (these are not reapairable - would have to be replaced - quite easy - small cost) 2. hard drive got damaged, creating some bad sectors- causing ps3 freeze every time it wants to read something out of this bad sectors (drive replacement - best shot - very easy - moderate cost) check on other television, as well as scart vs hdmi. if the problem persist, let us know