Este perfil no está completo aún.
Preguntas
I'm working on a5c in which the top and bottoms microphones are not working....phone does not record audio when recording...
Leer másI'm trying to refurbish a Samsung Tab 4, 7 inch model. When I press the power button, the Samsung screen appears for a few...
Leer másWorking on a 5s. This repair started as a standard replacement of a cracked screen. This phone was working fine prior to...
Leer másI'm trying to recover the data on a water damaged iphone 4s. I completely cleaned this phone and replaced battery. iTunes...
Leer másHave an Samsung Tab 4 that I'm trying to increase the brightness on. When I went to the brightness slider, I turned it all...
Leer másHello all, I'm working on a Samsung Tab 4, wifi only with screen brightness issues, specifically, the screen image can not...
Leer másHello all...I'm working on rehabbing an ipad 3, one thing that needs to be done is to replace the fcp for the LCD...
Leer másRespuestas
Look on eBay. Be sure to get one that is not icloud locked or has a bad imei number. The logic boards are not too difficult to switch out if you have the right tools.
Leer másBean, more than likely the heat is being generated by an electrical short. The minerals in water will cause corrosion that will build up and eventually start to bridge components and connectors that should be isolated. To find out if this is the case, you will have to examine the logic board under a microscope or if you don't have one, then use the strongest magnifying glass that you can find. Their is some protective tape that surrounds the LCD, Digitizer connectors. That tape can be removed from the logic board, do it carefully so that you can reuse it later when reassembling. Once tape is removed you can view the solder joints for the different connectors, Look for corrosion around the LCD and Digitizer connectors as well as all other parts that are on logic board that are not covered with the metal heat shields(both on the logic board and on the end of the flex cable). If you find some, then use a fiberglass scratch pen or soft toothbrush to remove corrosion. Rinse with alcohol. Water and electricity...
Leer más