Which parts are required to complete a screen replacement

Question

iPad 3 4G

Tercera generación de iPad, con capacidades 4G, lanzada el 16 de marzo de 2012. Número de modelo A1430. Las reparaciones requieren calor y palanca cuidadosa.

Preguntas 106 Ver todo

jwesleym @jwesleym

Rep: 1

1

Publicado: 15 de may. de 2012

Opciones

Which parts are required to complete a screen replacement

I have replaced the digitizer on a few iPad 2nd gens. I typically replace the middle frame bezel every time I replace the digitizer. I haven't been able to find replacement middle frame bezels for the new iPad. I was wondering if the iPad 2 bezel would fit, since the old one typically gets some minor damage during removal of the digitizer. Also, is the adhesive similar between the generations?

-Thanks,

jwesleym

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No

Puntuación -1

Agregar un comentario

3 Respuestas

Solución Elegida

annon201 @annon201

Rep: 43

2

Publicado: 20 de may. de 2012

Opciones

I just did an iPad 3 Screen replacement,

For the most part, the replacement is about the same - and most of the adhesive is the same too (there are a couple of bits different, but nothing that should affect anything). The part I ordered came with the plastic bezel, I do not know how similar it is to the iPad 2 as I have never replaced the bezel with the screen in the iPad 2.

-David

Fue útil esta respuesta?

Sí No

Puntuación 1

1 comentario:

How much does the screen cost?

27 de jun. de 2012 - de ken kenequon

Agregar un comentario