Repara tus cosas Comunidad Tienda

Versión renovada del iPhone 3G con velocidades de procesamiento más rápidas. La reparación de este dispositivo es similar a la 3G y requiere destornilladores simples y herramientas de palanca. Modelo A1303 / 16 o 32 GB de capacidad / respaldo de plástico negro o blanco.

Preguntas 1500 Ver todo

Opciones

When I squeeze the screen and iPhone togeather the lcd goes white

My digitizer and Lcd are a bit loose from the iphone because the bottom part were the screws hold it in place broke and i lost the screws.

So when i squeeze the iphone a bit to hard the lcd turns white.

Is this a problem with

-The LCD connection

or

-The digitizer connection

or

-something else

Do i need a new LCD???

the top part does hang out of the midframe a bit it never fully locks in place and i cant screw it back in because the two metal rings that are on the digitizer broke off. would i need a new midframe and digitizer?

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación -1
Agregar un comentario

1 Respuesta

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

If your phone works fine otherwise then no need to replace any parts at this point. They are all functioning except for when you apply pressure! It may be that your midframe, the part that holds the LCD and digitiser isn't quite in the top slots, when you press it is lifting the connections in some way? I'd invest in some screws to secure the display/midframe and hopefully the issue should resolve

Fue útil esta respuesta?

Sí No
Puntuación 3

3 comentarios:

the top part does hang out of the midframe a bit it never fully locks in place and i cant screw it back in because the two metal rings that are on the digitizer broke off.

would i need a new midframe and digitizer?

- de

the top part does hang out of the midframe a bit it never fully locks in place and i cant screw it back in because the two metal rings that are on the digitizer broke off.

would i need a new midframe and digitizer?

- de

buy a new midframe. 1) it'll keep your screen in nice and tight and stop it falling out if you drop it, 2) with it in snug it should stop the connector lifting and giving the white screen. Hopefully! The only reason to buy a new digitiser is if the touch screen isn't working.The only reason to buy a new LCD is if you have no display. As you haven't mentioned that these 2 parts are faulty then hopefully (!) your problem should just be securing the front display properly. Good luck and let us know if it works.

- de

Agregar un comentario

Añadir tu respuesta

phil estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 2,757