Saltar al contenido principal

The Hover-1 Maverick's manufacturer part number is H1-MVRK-MNT.

Preguntas 1 Ver todo

Can I swap out the charging cords

I have two different hoverboards and I want to use the one I have a charging cord for the other one . But the plug in ports are diffent

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

2 Respuestas

Respuesta Más Útil

If you open the boards you will see the charging port connects to the motherboard with a small white two pin connector. Both boards should be the same. You can swap these over but make sure the wires go back on the same way they came off.

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

James Scott that is a pretty generic question you posted here. Unless we can see what you see, we can only give you a generic answer. Yes, you can. All you would have to do is to switch over the plugs. Most likely, you would have to cut them (leave enough wire on the plug) and then connect the proper plug to each wiring harness. Use crimp connectors or solder the wires properly. Here is the most important part. Make sure that plug contacts are connected in a way that they correspond with what those wires do. Make sure that the batteries use the same charge etc.

Post some pictures of what you have going on there and what you are going to try. Agregar imágenes a una pregunta existente

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

James Scott estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 49