Rep: 1
3
I just replaced the laser in an old gc, and it's moving, but the disk isn't spinning up. Not sure if that was already happening or if it's a new problem though. What can I try now?
Update: took it apart again to check for that solder ball, and now the disc spins, but the laser doesn't turn on
Es esta una buena pregunta?
Rep: 551
9
8
13
Go back over the connections you disconnected and make sure they are all connected correctly.
Fue útil esta respuesta?
Rep: 2.2mil
17
15
5
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 4
Todo El Tiempo: 100
2 comentarios
@sadmango, Did you remove the solder ball all lasers are supposed to be shipped with to make it transport safe?
- de Geir Ove Andersen
no, i didn't know there was one
- de just some mango