Saltar al contenido principal

Repair information for Whirlpool dishwashers.

Preguntas 76 Ver todo

Dishwasher stops after few seconds

Hello,

My dishwasher stops a few seconds after starting. It did that for a while and initially opening then closing the door would help it continue. Later it needed more open/close for it to do the job. Now it won’t continue at all. When I open it I see water at the bottom. Pressing cancel will drain this out. There are no beeps and nothing on the display to show why it is stopping. Any ideas what to try? Model # wdt910ssym0

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0

Comentarios:

Mon Nasser sounds like a bad door switch. Clean the door seal and the door opening make sure that there is no debris etc. Try to push the door a bit while you turn on your DW and keep holding it. See if that makes a difference.

- de

Agregar un comentario

1 Respuesta

Respuesta Más Útil

Hi,

Here’s the tech sheet for the dishwasher.

Try running the diagnostic tests as described in the sheet and check what error codes are displayed to find out what’s wrong.

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Añadir tu respuesta

Mon Nasser estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 4

Todo El Tiempo: 43