Saltar al contenido principal

Estación de carga para el controlador Dualsense PS5.

Preguntas 3 Ver todo

Dualsense Charging Station Tear Down Guide

One of the charging ports on my charging station is no longer working. I think one of the metal contacts that is supposed to spring up is trapped in the plastic housing. Does anyone know how to open this thing so I can try and re-seat it?

Thanks!

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 6
2 comentarios

I have the same issue too...

Can you make a teardown video in order to get to the broken metal contact

- de

Does anyone know where to get replacement spring connectors or prongs?

- de

Agregar un comentario

2 Respuestas

Respuesta Más Útil
  1. Take DualSense charger and front facing you, turn over so the bottom is up. Locate seam where plastic meets plastic and use wedge to open and pop the plastic internal clips.

Block Image

  1. Slowly lifting and working your way back, pull up and release clips to remove bottom piece.
  2. Remove four screws that hold the base to the charging ports and separate.

Block Image

Block Image

  1. If you want to further remove the side plates, remove the two screws located in the following two locations.

Block Image

Block Image

  1. Once all four are removed, slowly pull back on side panels to release the plastic clips that hold on side panels.
  2. Basic teardown complete!

Fue útil esta respuesta?

Puntuación 6
Agregar un comentario

I got one of these that was thrown out at my local gamestop because they said it wasnt charging. I had the same problem where one of the pins was not being exposed when the plastic part moves down. I just used a box cutter knife and used the edge to bend the flattened pin upwards so that it was poking out again. Dont bend them too much because i think they need to make contact with the metal underneath the plastic but just enough to get them poking up again.

You could probably use a tweezers or other small metal instrument to do this as well.

I didnt need to disassemble. It seems like its easy to fold them under the plastic housing that the controller pushes down to expose the connectors.

Unplug the unit before doing this, to be safe.

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Añadir tu respuesta

TT_El_Barto estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 6

Ultimos 7 días: 45

Ultimos 30 días: 193

Todo El Tiempo: 4,480