Repara tus cosas Comunidad Tienda

Lanzado en Septiembre 16, 2016. Modelos 1660, 1778. Disponible en GSM o CDMA / 32, 128, o 256 GB / Oro Rosa, Oro, Plata, Negro Mate y Negro Brillante.

Preguntas 2264 Ver todo

Opciones

Home button not working after screen change

I changed the screen on my phone. The original home button works fine with the original screen. It does not work with replacement. When i power it on it does not pop the unable to activate home button etc warning at all. in settings i can go into fingerprint section and select add print, but it does not register. home button does not work. Is it the home button cable on the replacement screen?

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
Agregar un comentario

2 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

The home button flex cable from the screen to the logic board will have a small tear. This usually happens at the 90 degree bend and might be hard to see without magnification. Your only solution is to replace the screen.

Fue útil esta respuesta?

Sí No
Puntuación 1

1 comentario:

it does seem as if it is the screen, as i stated the button is fine, so is the phone, as it works fine with the original broken screen.

- de

Agregar un comentario
Respuesta Más Útil

Opciones

I have had this issue in the past. The home button on the iphone 7&8 are not a actual “button”, they are just touch sensors. The only real way to keep your home button working is to switch over the original when doing a screen replacement, if not you will loose all functionality of the button. I replaced a screen on a 7 and switched over the home button, but the button didn’t work at all. I switched over the metal heat shield that has the original home button flex cable into the new screen and it started working fine. I also made sure that the bracket and the button itself were all aligned and tightened. Hope this helps, good luck!

Fue útil esta respuesta?

Sí No
Puntuación 1

2 comentarios:

Also you may have damaged the extension flex cable and the flex cable on the home button. Check for any small tears, they are extremely fragile.

- de

As i stated, the button works fine with the original broken screen. it is not possible to use the home button cable from the old screen as far as i know.

- de

Agregar un comentario

Añadir tu respuesta

sam caspian estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 87