Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Model A1285 / 8 or 16 GB capacity

Preguntas 250 Ver todo

What is the best way to open the device with a swollen battery?

I collect iPods and have found a couple Nano that have started the telltale signs of a swollen battery. I’ve tried following the steps in the guide to open my device, but they don’t work when the battery is even slightly swollen. I’m incredibly curious if anyone has even been successful with changing the swollen battery on this model. I’d appreciate ANY help that doesn’t include anything along the lines of “just throw it away”.

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

2 Respuestas

Try using a razor blade but with a chisel blade and once you release one catch undo the blade and leave it in and use another blade on the knife until it releases.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

The battery usually puff up because of internal gas discharge. I have no idea what gas they may be, but it’s just gas. To reduce the volume of gas, you can either use high pressure or low temperature; the former is harder, but the latter may be worth a try: I just opened a lightly puffed iPod nano 4th gen (the “wet mark” showing the screen contacting the glass panel was only about the size of a grain of rice) by freezing it in a conventional fridge (no idea the actual temp, maybe 0 F or -18 C). I used a sealed container with some desiccant for it; there should be very little chance of things going wrong.

Notice that if you work in a humid area, condensation may form on the iPod inside and out: make sure they are off and discharge the battery if needed. Once you get the screen off, everything else should be very straightforward. Make sure to let the iPod warm up to room temperature before pulling out the solder iron or trying to start it.

Hope this helps.

(P.S. I did damage the screen mounting hardware a bit before trying the cold method because I was too optimistic about the battery expansion… the display retainer pulled off and the screen metal bracket is bent. The battery also didn’t give up without a minor hassle, so be more careful than I was.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Era estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 9

Ultimos 30 días: 17

Todo El Tiempo: 30