Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Lanzado en Septiembre 16, 2016. Modelos 1660, 1778. Disponible en GSM o CDMA / 32, 128, o 256 GB / Oro Rosa, Oro, Plata, Negro Mate y Negro Brillante.

Preguntas 1801 Ver todo

Can I disconnect battery cable while the iPhone 7 is on

I’m trying to repair an Iphone 7 that suffered a cracked screen and then water damage. I replaced the battery and tried to boot it up and its now stuck on a black screen with apple logo. I want to try replacing the screen now but I’m now stuck on this screen.

  1. will replacing the screen fix this apple logo stuck screen?
  2. How can I fix the apple stuck screen logo?
  3. Do I need to wait for the battery to drain, or can I just disconnect the cable from the phone to the battery?
Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

1 Respuesta

You can disconnect the battery from the phone and it won't hurt it. Just don't disconnect the screen until the battery is disconnected. Changing the screen will not get rid of the apple logo. It's in a boot loop. It most likely has a problem from water damage. The problem is once they are wet they have problems for the rest of there lives IF you can get them working again. Most repair shops won't even work on them except to retrieve data when they are water damaged. If you want to try to fix it you need to pull the board out and remove the covers and see how bad it's corroded. Save the covers for the chips in case you can get it working. Once it gets wet it starts corroding and it does it faster if it has power connected to it. Did you try to charge it after? The first thing you should have done is open the phone and disconnect the battery and pull the board out and remove the covers on the motherboard and dry it off with a heat gun or hair dryer. Then clean any corrosion with a qtip and alcohol. See how bad it's corroded and you might try cleaning the board and see what happens.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

derek estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 7

Todo El Tiempo: 12