Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y Herramientas

Lanzado en Septiembre 16, 2016. Modelos 1660, 1778. Disponible en GSM o CDMA / 32, 128, o 256 GB / Oro Rosa, Oro, Plata, Negro Mate y Negro Brillante.

Preguntas 1469 Ver todo

Loop mode after changing battery

Replaced my iPhone 7 battery yesterday. I’ve done this in the past with my old iPhone so I felt fairly confident. Followed directions and all seemed to go smooth. When powered back on, my phone is stuck in loop mode and won’t fully start up. Rechecked all my cables and all seem fine. After further investigation I realized my phone would fully start up and work if I left the home button cable unplugged. Home button obviously doesn’t work, but everything else works fine. Any ideas what my issue may be??

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0

Comentarios:

My phone charges up and works fine without the shorter home button cable plugged in (other than not having a home button). I’m actually using it right now. It just won’t start up when home button is hooked up. Does this point to an issue with the home button or is it possible that it will boot up if I leave it in loop mode for a while?

- Por

Agregar un comentario

2 Respuestas

Respuesta Más Útil

From your case it would be either one of the following:

The home button flex cable on the home button itself has been torn. Extremely unlikely if the metal bracket for the home button was not removed from the screen.

The most likely cause is a microtear on the screen cable itself. It'll be the smaller cable specifically coming from the screen and not the front camera.

The part where it tears is behind the metal shield that goes on top of the back of the screen.

Hopefully just the screen needs to be replaced rather than the home button which if it is the latter would required to be replaced by an aftermarket one with no touch ID.

Fue útil esta respuesta?

Puntuación 1

Comentarios:

Ben is right. This is a common problem after removing and replacing the screen. If you leave it long enough it should boot and you can confirm.

- Por

Agregar un comentario

Check the parts near the battery connector. Be sure that battery is charged or connect to battery connector properly.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

CHRISTRUSCH88 estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 34