Saltar al contenido principal

Lanzado en Septiembre 16, 2016. Modelos 1660, 1778. Disponible en GSM o CDMA / 32, 128, o 256 GB / Oro Rosa, Oro, Plata, Negro Mate y Negro Brillante.

Preguntas 1361 Ver todo

iPhone 7 and 7 plus stuck on apple logo after replacing the housing bo

Hi, I replaced the housing body frame of Iphone 7 and 7 plus.

but after everything was installed on the new housing place and put the screen back, I tested out by turning on the phones. Then both of them stuck on Apple logo. I tried to hard reset but nothing works. Just to make sure if the charging is working but when I plugged it in, it doesn’t sound or vibrate at all.

Could someone suggest me what the potential issue here or what I can try…?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1
Agregar un comentario

1 Respuesta

test them out of the housing with the logic board, screen, battery and charging dock connector and then do a prompt to boot a iphone

good luck

Fue útil esta respuesta?

Puntuación 0

1 comentario:

Thank you for your advice. Did you mean that I should test them each by each by replacing each parts as you mentioned to find out which parts is causing this problem?

- de

Agregar un comentario

Añadir tu respuesta

Alltech estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 56