Accessories not gripped tightly
After tightening an accessory into place with the collett nut, it doesn’t grip enough, so tool such a saw just stops when pressed against object.
Es esta una buena pregunta?
Puntuación
0
582177
1 Respuesta
Respuesta Más Útil
Rep: 8.2mil
24
12
8
Measure the shaft on the tool in question. It is probably 3/32” and you probably have a 1/8” collet installed in the collet nut. If you have lost that part or did not get it with the tool they are readily available on line.
Fue útil esta respuesta?
Puntuación
2
