Saltar al contenido principal

Fix Your Stuff

Right to Repair

Parts & Tools

Non-Unibody, Core Duo & Core 2 Duo Processors

Preguntas 492 Ver todo

Why won't 3 screws near battery go back in, after display install?

I have two a1229s and I recently swapped out a full display assembly following the manual on ifixit. Everything went fine except I can't get 3 screws back in

These 3 - http://guide-images.ifixit.net/igi/WKwoX...

(the ones under the battery, on the opposite side of the battery as the ram door; they're tilted at an angle)

First, I'm not certain which screws go back there, because i combined the screws from both mbps, and don't necessarily plan on reassembling the other one, as I'll probably just sell the parts).

I assume it's the short screw with the large head, but I tried every different type of screw and none would lock in. I feel like I could probably just manage fine without having these three screws in there, but if anyone knows how to fix this issue, or can even tell me for sure which screws should go in there (though, I made a good effort with all of them - and all 3 holes - so that's not the main issue), I would be interested and appreciative.

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

1 Respuesta

Respuesta Más Útil

If those are the same as on a 15", they are 2.8 MM while the perimeter case screws are 3.2 mm.

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

Añadir tu respuesta

thomas cares estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 606