iPhone 6S half backlight need solution

Question

iPhone 6s

Lanzado el 25 de septiembre de 2015. Modelo A1688 / A1633 . La reparación de este dispositivo es similar a las generaciones anteriores, que requieren destornilladores y herramientas de palanca. Disponible como GSM o CDMA / 16 , 64 , o 128 GB / plata, oro, gris espacio, o la opcion de oro rosa.

Preguntas 2687 Ver todo

Ajit Sable @doctorgadget

Rep: 35

2

1

Publicado: 18 de mar. de 2019

Opciones

iPhone 6S half backlight need solution

I got device which was having no backlight at all , after diagnosis I found the filter capacitor was Burnt instead of changing the capacitor with new one , I did direct jumper , this cause backlight came but the half side of lcd , how to get other half backlight of iPhone 6S

should I put the capacitor on , or change the backlight ic ?

Please share the solution I and Save the phone , as this is my first quation to the forum , please guide me, thank you .

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No

Puntuación 2

Agregar un comentario

2 Respuestas

Solución Elegida

arbaman @arbaman

Rep: 102.6mil

10

54

291

Publicado: 18 de mar. de 2019

Opciones

There is no way to tell for sure without testing where the problem is. Backlight is brought to screen with one anode and two cathods. Each line protects the board with one filter, which is there to shield the backlight driver and components. Sometimes damage is limited to the filter, other times it goes further. Bridging a filter is a bad idea as any injury to the screen next time will likely directly destroy the backlight driver, capacitors, inductors and so on.

You can try replace all filters, if backlight is still half faulty you’ll have to dig deeper in the circuit.

Fue útil esta respuesta?

Sí No

Puntuación 1

2 comentarios:

i change one capacitor , could you tell us which is another filter capacitor of backlight

18 de mar. de 2019 - de Ajit Sable

@doctorgadget You'll have to replace FL4211, FL4212, FL4213 or make jumpers for testing purposes. They're not capacitors though, they're ferrite beads. If you were to bridge a capacitor all you would get would be a shorted to ground line.

19 de mar. de 2019 - de arbaman

Agregar un comentario

i change one capacitor , could you tell us which is another filter capacitor of backlight — Ajit Sable
@doctorgadget You'll have to replace FL4211, FL4212, FL4213 or make jumpers for testing purposes. They're not capacitors though, they're ferrite beads. If you were to bridge a capacitor all you would get would be a shorted to ground line. — arbaman