Saltar al contenido principal

Información y guías de reparación para el iPhone 6 que salió a la venta el 19 de septiembre de 2014. Números de modelo: A1549, A1586 y A1589

Preguntas 4994 Ver todo

iPhone 6 Logic board not booting. DCPS shows 200 mA draw

Slightly water damaged iphone 6 totally dead.

removed the logic board, all the shields, & cleaned in ultrasonic solution branson EC, …

Found no shorts anywhere( vcc main, pp_cpu, pp_gpu, var, sdram, …). Also all the rails’ voltages seem to be in range.

Connected the Logic board only to DCPS. It does not even boot but draws 200 mA.

PMIC gets warm but not hot.

help would be appreciated!

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

2 Respuestas

Solución Elegida

Did you check ALL of the PMIC outputs or just the main ones? A faulty subsystem can pull the whole system down as well and it is often overlooked. If they all check out, then check the main subsystems that aren’t powered by the PMIc, such as MESA,CHESTNUT, BACKLIGHT. Then check the I2C lines to insure they are balanced and within range and take a look at the PMIC Reset lines (those that can be probed) to see if the problem is there.

Finally, check the BBPMU outputs as well as a damaged BB system will impede the phone from booting.

Also, what areas of the board were more corroded, that could give you some clues about where the damage actually is.

Fue útil esta respuesta?

Puntuación 2

4 comentarios:

Update:

PP 1V8 SDRAM rail reads 0.52 V

???

- de

Check that power rail with the phone unpowered in diode mode to see what reading you get. There may be a partial short that you will need to elucidate.

- de

Found the shorts:

Backlight driver —> 0.18 A

U5302_RF —> 0.02 A

Both are removed.

No booting ( from zero goes to 0.12 A & repeat itself)

DFU recovery on iTune recognizes the board but haven’t gone farther. (Did not recover). Trying not to loose data.

?

- de

PP 1V8 SDRAM. Ow reads correctly 1.8

- de

Agregar un comentario
Respuesta Más Útil

Does it show 200ma when dcps is connected or after button press. If it's after button press I would check tristar

Fue útil esta respuesta?

Puntuación 2

2 comentarios:

It draws 200 mA before pressing the button.

After button press just a blip & stays on 200 mA.

Could it be a faulty PMIC?

- de

Before removing the pmic remove Tristar and then see what it does on dc

- de

Agregar un comentario

Añadir tu respuesta

Hama estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 3

Todo El Tiempo: 373