I accidentally ripped a flex on the front camera module. I managed to get the flex unsoldered from the sensor. I plan to order a new front camera module and transfer the flex from it. I don't know if it's been done or attempted, but wish me luck.
Es esta una buena pregunta?
Rep: 221.4mil
15
289
806
Use low heat and don’t overdo it with the flux as you don’t want it going into the actual camera. I would also practice on a few dead flexes (from less expensive parts) if you haven’t worked on flexes before.
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 0
Todo El Tiempo: 224
1 comentario
I wish you the best of luck with the repair! I believe this might be possible but time will tell if it actually is.
- de [deleted]