iPhone 6 Plus sometimes auto restart?

Question

iPhone 6 Plus

Lanzado el 19 de septiembre de 2014, este iPhone de pantalla de 5.5" es la versión más grande del iPhone 6.

Preguntas 1525 Ver todo

Azim WHITE @azimwhite

Rep: 263

5

13

Publicado: 26 de jul. de 2018

Opciones

iPhone 6 Plus sometimes auto restart?

Hi I got an IPhone 6 plus water damaged and came with short on VCC_Main Cap near the Audio IC. After removing the shorted Cap the phone works normally, but then after a few days the phone came in with with a new issue :

.

1. Always restart itself

2. Battery percentage is not normal, like sometimes 80% and directly decrease to 5% and suddenly it turns off.

.

So I take a further step by changing the Charging IC (U1700). After changing the Charging IC the IPhone works well, but just for a few hours the issue CAME BACK (but the percentage issue is solved). Diode Mode on Vcc_Main looks normal to me around 350.

.

So my question is, do I need to change the Tigris Chip ? Is it possible that the issue came from the CPU ? What should I do next

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No

Puntuación 0

Agregar un comentario

2 Respuestas

Solución Elegida

Minho @refectio

Rep: 221.4mil

Refectio - Mail-in Micro-Soldering Repairs & Data Recovery

15

289

806

Publicado: 27 de jul. de 2018

Opciones

It seems to me like you are just guessing at what the problem is. That can work, sometimes, as there are typical failure points but the issue is that every time you apply heat to replace an IC, you are risking collateral damage.

A restart issue can be caused by a lot of things and Tigris is really only used for charging, which you repaired. So changing Tigris for no reason is not a good use of your time.

Have you properly decontaminated the logic board? If you have, then start probing the PMIC / BBPMU outputs and compare to a known-good device. Then check the I2C and RESET lines to see if anything weird is going on.

Fue útil esta respuesta?

Sí No

Puntuación 2

3 comentarios:

How can I know which Cap is the output for the PMIC/BBPMU ?

27 de jul. de 2018 - de Azim WHITE

Look at the schematic and identify all of the outputs (i.e. PP_CPU, PP_GPU etc.) then look for the best testing points (i.e. C1290, C1203). BBPMU is the power unit for the baseband circuit and is different than the PMIC.

27 de jul. de 2018 - de Minho

Okay ill try to check it back tomorow and also ill update about the result soon. Thnx your suggestion was very helpful

27 de jul. de 2018 - de Azim WHITE

Agregar un comentario

Look at the schematic and identify all of the outputs (i.e. PP_CPU, PP_GPU etc.) then look for the best testing points (i.e. C1290, C1203). BBPMU is the power unit for the baseband circuit and is different than the PMIC. — Minho
Okay ill try to check it back tomorow and also ill update about the result soon. Thnx your suggestion was very helpful — Azim WHITE