Saltar al contenido principal

Laser sensor, four buttons, trackball

Preguntas 11 Ver todo

After cleaning the ball doesn't work anymore

I have cleaned my Mighty Mouse several times following your instructions manual, but the last time I did it, the ball doesn't function anymore. Any thing I did wrong? I have used this procedure several times, and I'm sure I reassembled it correctly. Maybe the cables or the cables connectors are with problem, is it possible?

What can I try to correct this problem?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Calificación 0
Agregar un comentario

1 Respuesta

Respuesta Más Útil

we find that most cases you can clean it from the outside by rolling the ball with a cleaning substance. But while doing this cleaning method does pull out some dirt that stops the ball mechanisms from rolling (there are 4 directional pins inside), the pins eventually get too clogged up to roll.

The only way of fixing it after that is to open it and clean it from the inside. it can be done, but will require cracking the lower frame off the mouse, then re-glueing it afterwards

Fue útil esta respuesta?

Calificación 1
Agregar un comentario

Añadir tu respuesta

sergio barrozo estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 16