Released September 22, 2017. Model A1863, A1905. Available as GSM or CDMA / 64 or 256 GB / gold, silver, and space gray.

Preguntas 177 Ver todo

Battery percentage stuck at 1%

After replacing the iPhone 8 display, the battery percentage shows 1% and its not charging at all. I tried the following but none fixed the problem:

1) Wireless charger and several different wired chargers with different cables but no chance.

2) I am sure the charging port is fine since iTune recognizes the phone via USB connection.

3) Hard reset didn't help

4) iOS Update didn't (11.3.1)

5) Put the original broken display back on, still not charging.

I was wondering if anyone experienced this problem and found the solution ?

Contestado! View the answer Yo también tengo este problema

Es esta una buena pregunta?

Calificación 3
Agregar un comentario

¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

Visita Nuestra Tienda

3 Respuestas

Solución Elegida

I don’t have pictures but have seen this before: there is a small component near the battery connector in the iPhone 8 that constantly gets knocked off during repair, leading to this failure.

It is an easy fix for a good microsoldering technician.

Fue útil esta respuesta?

Calificación 5

Comentarios:

Thanks Rany, I checked the phone in my rework lab with microscope and you are right that chip is missing and unfortunately for some reason my ZXW is not working at the moment to find out what it is, hence I was wondering if you know what the component is ?

por

Umm, I am sick with bronchitis, not at the lab.

Besides there is no iPhone 8 on ZXW yet IIRC.

Your best bet is to look at a good board or ask someone who has a good board to measure it for you. I think there is something stupid like a resistor on the gate line? Not sure anymore.

por

I contacted everyone but no chance to find iP8 component schematic but finally a colleague from UK sent me the chip specification which is classified as a "ROHM Semiconductor".... I better not to mention the part no. at this stage to prevent confusion till I receive it and try it then I will share the details.

por

its fixed, the chip is RV3C002UN, It took me a while because couple of pads were gone too.

por

Bezad where you got this chip from. Looks like am stuck in same position as well

por

Mostrar 9 comentarios más

Agregar un comentario

Did you try reseating the battery cable?

It can sometimes be as simple as that as I've had a few cases where the battery ribbon cable got partially disconnected when removing the metal shield that also covers the screen cables.

Fue útil esta respuesta?

Calificación 1

Comentarios:

Thanks Ben for the tip, unfortunately it wasn't the the battery ribbon but a little damage to the PCB close to battery terminal which "Rany" addressed.... I am working on the logic-board and when its fixed I will share the information.

por

Agregar un comentario

Hey @bezad53, did you ever end up snapping a picture of where the component was on the board? I have the same issue and have ordered the component listed above - just want to verify that I'm looking in the right place.

I have a pic of the logic board if you could indicate where you did your repair. Thanks!

Pic:

Block Image

Fue útil esta respuesta?

Calificación 0
Agregar un comentario

Añadir tu respuesta

Bezad estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 46

Últimos 7 Días: 374

Últimos 30 Días: 1,729

Todo El Tiempo: 15,960