Saltar al contenido principal

Released on September 19, 2014, this 5.5" screen iPhone is the larger version of the iPhone 6.

Preguntas 1450 Ver todo

Unresponsive iPhone 6plus screen turns on but screen doesn’t work

I have a I phone 6plus I replaced the screen I few months ago because it had the touch disease. It turns on fine but won’t allow me to touch anything on the phone I keep replaying my screen because it’s unresponsive i want to know how to fix it permanently. If someone can help that would be great

Contestado! View the answer Yo también tengo este problema

Es esta una buena pregunta?

Calificación 0
Agregar un comentario

Skip the upgrade.

Descuento de $10 en tu factura de $50 con
SKIPANDSAVE10

Save Now

Skip the upgrade.

Take $10 off $50 with
SKIPANDSAVE10

Save Now

2 Respuestas

Solución Elegida

Touch Disease is a very common failure on the iPhone 6 Plus.

At first, the phone will typically develop intermittent touch control failure. For some phones, a gray/white bar starts appearing at the top of the screen. Twisting and applying pressure in certain spots sometimes allows touch control to work for a short period of time, but eventually, the touch interface ceases to function entirely. This is colloquially known as Touch Disease.

If you are confident that your replacement screen is fully functional and there is no damage to the Digitizer FPC connectors on the logic board, then your phone probably suffers from Touch Disease. This is not a DIY repair.

 The current best practice for permanently repairing Touch Disease on the iPhone 6 Plus is to solidify the M1 pad underneath the Meson Touch IC. That pad tends to lift, partially or totally when removing Meson.

Look for a repair shop that can do micro-soldering repairs to properly diagnose your problem.

Fue útil esta respuesta?

Calificación 2
Agregar un comentario

touch disease is related to the ic chip on the rear of the board. dont keep replacing screens none will fix it...you can put a old sim card under the protective plate covering your lcd cables that will push the board back on to the ic chip ...you could also use a small tip and reheat the solder then push them back to the chip till they cool. there are quite a few videos showing solutions on youtube.

Fue útil esta respuesta?

Calificación -1

Comentarios:

Reflow and adding pressure are temporary solutions.

Real soltuion is to replace the touch ic.

por

As maybe the case. However temporary is a subjective term. Should the temporary fix last till the owner upgrades then it's not very temporary.

por

Agregar un comentario

Añadir tu respuesta

Alexis estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 5

Todo El Tiempo: 53