Saltar al contenido principal

Lanzado el 25 de septiembre de 2015. Modelo A1687 / A1634. La Reparación de este dispositivo es similar a las generaciones anteriores, requiriendo destornilladores y herramientas de palanca. Disponible como GSM o CDMA / 16, 64 o 128 GB / Silver, Gold, Space Grey o Rose Gold.

Preguntas 1041 Ver todo

Taptic engine not working - how to test outside of phone.

I got a client's phone today that is not vibrating. It was previously jailbroken, and had the issue a few months after that. Now after damage, no signs of drops, I'm the "first one" in it. (found some finger prints in the speaker)

I'm not sure if it has a bad lightning assembly, taptic engine or something else. I don't have spare parts to test at the moment. Any idea how to test it outside of circuit? Or any pin outs for it? Ideally I'll have another iPhone 6sp come in to try this one in that phone, but I'm not holding my breath.

Thanks

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
2 comentarios

could you not add voltage to it guessing about 3v

- de

I could, but with what current and to what pins? It has a flex cable going to the lightning dock with about 10 pins I think? I don't have it in front of me.

- de

Agregar un comentario

3 Respuestas

Respuesta Más Útil

Try to get a dc power supply and take out the Taptic Engine then slowly increase the voltage to it to see if it moves. Or get a multimeter and measure the voltage across the pins on the lightning connector and make it vibrate and see if any voltage comes up.

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

ideally you should get some test parts as trying to test it could be the hard part and still not lead anywhere

Fue útil esta respuesta?

Puntuación 1

2 comentarios:

Yep, ideally I would. But I am looking for another solution that's why I posted here and why I said I don't have any test parts. Unfortunately I don't see any output on ZXW for its plug as it is on the lightning assembly.

Do you have a working one? An oscilloscope you could test the output frequency and voltage with? That would be super helpful.

- de

i dont only iphone 6 and i dont use an oscilloscope, can you not change vibration settings in sound to see if it works

- de

Agregar un comentario

I have this problem with my 5S, he must of installed some Taptic tweak. If you press the bower button and volume up and down buttons at the same time you should feel a vibrate. Sadly updating the phone doesn’t fix it, and neither is restoring the phone from a back up.

The Fix. You will have to reset the entire phone and not restore it from a back up.

(Back up info just in case)

Fue útil esta respuesta?

Puntuación 0

1 comentario:

I did a DFU restore from a new firmware I downloaded from Apple. 11.0.3. Phone is like new now, but still no luck on the Taptic problem... I think tomorrow I will recieve the parts, but the person needed their phone back - Maybe I will get my hands on it again in the future.

- de

Agregar un comentario

Añadir tu respuesta

Joseph Hughes estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 6

Ultimos 30 días: 18

Todo El Tiempo: 4,648