Saltar al contenido principal

Una batidora original de Ken Wood en Gran Bretaña, ahora propiedad de De'Longhi

Preguntas 73 Ver todo

If the stand mixer only runs on the highest speed but not on medium

My stand mixer only runs on the highest speed ,when I turn on the dial ,the switch knob it immediately runs on the last speed ,does not come down to medium or low speed ,what might have gone wrong ? Is it the PCB or just the speed knob / assembly?

Pls advice what is it ? I have accurately described the problem ,it is just THIS problem ,else the stand mixer works fine .

Many thanks ,

Kindly pls suggest

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
2 comentarios

Hi Husna, what make and model is your Kenwood mixer?

- de

Ok have a kenwood chef major

- de

Agregar un comentario

3 Respuestas

Respuesta Más Útil

The speed issue could be related to the spark suppression capacitor for the governor. If it shortens out the motor will run at full speed only. The capacitor is located under the Bakelite cover that covers the motor bottom. Remove the cover and you should see the capacitor. You can always post images of what you find with your question by using this guide Agregar imágenes a una pregunta existente That way we can see what you see.

If that capacitor is good you can try to adjust the speed by using this guide which should be similar to all Kenwood's. Like @blakeklein already mentioned, let us know what exact model this is so we can help you further if needed.

Imagen de iFixit

Guía

Agregar imágenes a una pregunta existente

Dificultad:

Muy fácil

2 - 5 minutes

Imagen de Kenwood Chef A701A

Guía

How to adjust Kenwood Chef A701A minimum speed

Dificultad:

Fácil

15 - 30 minutes

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Can you smell burning? If yes one of the capacitors may have blown. On mine I turned it on it's back and open the catch. Then undo the two screws holding a metal plate and you should then be able to open it further and move the plastic cover out of the way. You should then see the circuit and possibly a blown capacitor. If it is that you can just replace the capacitor. Hope that helps.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Where do I but a spark suppression capacitor from for my A701A kenwood mixer and part no please?

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Husna Bano estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 28

Ultimos 30 días: 133

Todo El Tiempo: 5,980