Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Repair guides and information for the Nintendo Switch Joy-Con controllers.

Preguntas 55 Ver todo

Replaced joy-con shell; bungled joystick?

I did a shell replacement on my whole Switch, including the body and both joy-cons. Everything went great except for the right joy-con: I must have screwed up the joystick because now it’s permanently sending “joystick right” anytime it’s connected to my unit. The joystick itself looks just fine, it doesn’t look bent. The only thing I can think of is maybe I screwed up the ribbon cable when I plugged it back into the joy-con circuit board.

Has this happened to anybody else? If so, is there a fix? If not, is there a place I can buy a new joystick assembly for the right joy-con?

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 3
Agregar un comentario

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

1 Respuesta

Respuesta Más Útil

I have a similar issue - try lifting the rubber flap that covers the Joystick guts (just under the stick). Then blast some compressed air into here and move stick blast, move stick, blast. See if that helps. Then run the analogue stick configuration from settings.

Fue útil esta respuesta?

Puntuación 1

Comentarios:

How did you get the rubber cap back on? It won't fit in for me.

- de

You list it back with two pins it will flap and stay back if done right. A little fiddly but if not you hold while someone else sprays

- de

Agregar un comentario

Añadir tu respuesta

Ben Kreeger estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 6

Ultimos 30 días: 16

Todo El Tiempo: 2,168