Repara tus cosas Comunidad Tienda

Información y guías de reparación para el iPhone 6 que salió a la venta el 19 de septiembre de 2014. Números de modelo: A1549, A1586 y A1589

Preguntas 4994 Ver todo

Opciones

What causes these LCD marks?

Hello,

I have replaced a iphone 6 screen and the frame. After putting everything togheter i notice this mark on the LCD. The screen is a little stressed. Did i do this damage when repairing the device or is there something wrong with the screen? I have repaired a new screen today, and i notice the same thing, but in very small amount.

You can only see it clearly when the screen is compeltely white, so it is not a very big problem.

The screens are high quality copy screens. (MiC)

Thanks!

Block Image

Block Image

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
Agregar un comentario

2 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

The small white area is caused by excessive pressure. Remove the screen from the housing but keep it connected. If the mark is still there, then it may be a defective replacement screen.

The screen should not be stressed when properly installed. Look for debris that may be causing this.

Fue útil esta respuesta?

Sí No
Puntuación 3

3 comentarios:

Thank you Minho. When removing the screen the mark goes away. I have tried removing the LCD shield plate and clean for debris. It is better now, but the mark is still there. I am not sure what the cause might be. What i noticed is that when i apply pressure to the LCD plate, the white area appears. So it must have something to do with that. But as i said, the area behind the shield looked really clean.

- de

It doesn't take much. Inspect it again...there must be something somewhere causing this.

- de

After a lot of cleaning/reassembling i got the worst of it away. It seemed to me some sand/small corns on the screen flex. Scraped that away and it worked again

- de

Agregar un comentario

Opciones

That could be pressure, heat, water damage or bad display manufacturing(vacuum related usually)

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Añadir tu respuesta

Iver estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 2

Todo El Tiempo: 2,270