Saltar al contenido principal

Model A1288 / 8, 16, or 32 GB capacity

Preguntas 562 Ver todo

Digitizer replacement does NOT work!?

I recently bought an iPod Touch 2nd gen with a cracked digitizer. I have replaced many of these in the past, and have done many other numerous iPod repairs on all other iPod models.

So I took off the broken digitizer, and put it the new one. I did not secure it to the iPod Touch, just in case it wouldn't work. I then powered it on to test it. Of course it didn't work! My digitizer was OEM, and was purchased from the same seller that I had bought from before.

I had another OEM digitizer that worked in my house, and so I tried that one. Again, no luck. I then took it all apart, cleaned it, assembled it back together, plugged and unplugged the two different digitizers multiple times, and haven't gotten any response!

Any help? Anyone else have this same problem?

Thanks!

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1
Agregar un comentario

3 Respuestas

Respuesta Más Útil

Sounds like more than the digitizer is broken, open it up and see if anything else is obviously broken.

Fue útil esta respuesta?

Puntuación 1

Comentarios:

I looked, and nothing else is physically broken. It's as dirty as Satan in there though. That's partly why I unassembled it- to clean the iPod.

I sure hope it's not the motherboard. Those are worth more than the iPod itself! :(

- de

It might be worth to clean it then.

- de

Agregar un comentario

Yeah. I wish I had a tool to REALLY clean it. Any ideas?

Fue útil esta respuesta?

Puntuación 0

Comentarios:

All I can think of is compressed air.

- de

Agregar un comentario

Did something work?

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

iball1804 estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 4,905