Rep: 2.4mil
12
40
2
Cut the cable removing the old screen, but had one on hand just in case. Installed, didn't work. Assumed it was defective, ordered another. Also doesn't work. No visible damage anywhere. whats going on??
Es esta una buena pregunta?
Rep: 383
3
Austin, I would say inspect the flex cable for your digitizer however you have installed two and both do not work my first question is did you buy them from the same place? If so that may be your problem, that supplier may have run a bad batch of digitizers with flex cable discrepancies. I would return them and get my money back then buy one from this website, believe me it will be worth the extra few bucks you may spend. If you bought it on Amazon or Ebay only go with highly rated suppliers with high feedback rankings, 4 stars or above and also a considerable amount of feedback. If you look and it says five stars 15 times find another supplier with higher numbers. The only thing you could do now is inspect the flex on the digitizer and the connector on the logic board to ensure there is no damage. If you find damage on the logic board connector you may have to have a board level repair performed. Hope this helps!
Fue útil esta respuesta?
Rep: 323
5
2
I agree with Mark’s good advice. You could also just check to make sure that the connector end of the flex is not smudged by oil residue from your fingers. This can also be enough to keep it from making contact. Clean the contact with alcohol and then try it again.
If that doesn’t do it, you can always replace the home button assembly and flex. I’m sure you can find the parts here on iFixit.
Fue útil esta respuesta?
Ultimas 24 horas: 0
Ultimos 7 días: 1
Ultimos 30 días: 2
Todo El Tiempo: 239
Anyone? I feel as though im not the first one to have this problem.
- de Austin Harris