Saltar al contenido principal

Repair guides and support for tablets produced by Lenovo including the ThinkPad tablet line.

Preguntas 464 Ver todo

Broke the connector for digitizer on the logic board

Block Image

I was about replacing the screen (not the digitizer) on my tablet Lenovo A7600-f. Unfortunately I broke the connector on the logic board trying to remove the old digitizer connector. It is gone completely, so I can not connect the new screen. Do I have to change the whole logic board or am I able to buy a new connector and mount it on the logic board? Would be grateful for tip where to buy and how to mount the new connector if possible?

It was the first time trying to repair a phone/tablet myself so my confidence is low right now.

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

1 Respuesta

Solución Elegida

If you are able to do micro soldering then you can replace the connector . Finding the connector my be an issue . You may have some luck finding it with aliexpress. You may have a better time replacing the whole board. Hope this helps

Fue útil esta respuesta?

Puntuación 1
Agregar un comentario

Añadir tu respuesta

Joakim Rydström estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 169