How to access timing belts
How to remove the covert to the timing belts on a BBA 2865 breadmaker machine
Es esta una buena pregunta?
Puntuación
0
361550
2 Respuestas
Respuesta Más Útil
Rep: 25
1
Belt is at the bottom of the machine.
You need to:
- Remove the inner heat shield. It has 8 screws at the bottom and one on the side wall which is holding the heater. Remove it gently.
- Remove the top of the machine. Do not need to remove the lid. Just open it, remove the screws caps beneath the lead. There are 5 screws. Unhuk 7 plastic hooks just below the top.
- Remove base with the circuits, motor and heater. Unscrew all 6 screws. Remove GND (green and yellow) wire. Disconnect mains power connector from the circuit board. Gently pull out the base, watch for the on/off button.
- Remove the broken belt or wheel. Replace the belt or wheel.
- Put everything back in reverse order.
Fue útil esta respuesta?
Puntuación
2
Rep: 25
1
Update (03.12.2022)
It cost me a lot of nerves to get the white plastic clips off. They are also a pain to clip back on later.
So finally, here the top is off, ready for the white plug to be unplugged:
The earth cable still has to come off:
Now take care of the on/off switch:
The switch cables can stay plugged in. Mine were so hard in, I feared to break them off. Just be careful.
Important for later assembly: the three spacers.
Now the way is clear to replace the timing belts.
Fixed. View from underwards:
Good luck! ;-)
Fue útil esta respuesta?
Puntuación
2
