Saltar al contenido principal

Información y guías de reparación para el iPhone 6 que salió a la venta el 19 de septiembre de 2014. Números de modelo: A1549, A1586 y A1589

Preguntas 4994 Ver todo

ERROR 4005 after liquid damage

Here I have a iPhone 6, the issue is with the logic board itself

logic board had liquid spill which I have cleaned. plugged it into charging and it was in a apple logo loop, apple logo would appear for a few seconds then turn off.

I put it into recovery mode, the phone wouldn't restore, keeps saying waiting for iPhone then error 4005.

Anyone encountered this issue?

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

1 Respuesta

Solución Elegida

This is a belated answer so hopefully it can be of use to folks who search for and find this question.

iTunes Error 4005 can be NAND or SDRAM related. Generally speaking, you should closely inspect and probe the circuitry that was the most visibly damaged by the liquid. If that doesn't allow you to identify the problem, then take a logical approach and start checking all of the voltage rails generated by the PMIC and then the BB PMU. Usually that will give you some leads.

If the power side of the board is good, then start checking the I2C & RESET lines. Not every logic board is repairable and you have to learn when to call it quits. Every board can be a learning experience but at some point you have to focus on repairable devices.

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

Añadir tu respuesta

Waseem estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 287