Saltar al contenido principal

Support for gas-powered and electric golf carts, sometimes referred to as golf cars or club cars after the Club Car Golf Cart brand.

Preguntas 451 Ver todo

won't start,new battery and solenoid.

Golf Cart yamaha g16 gas new battery and solenoid. will start if solenoid is jumped. I have checked all fuses. any suggestions help.

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 2

Comentarios:

@mezkin it will start every time you apply a jumper to the solenoid?

- de

We have the same problem. Brand new battery and solenoid. Can jump solenoid. When key is on lights work and in reverse position beeps but when you push on petal nothing happens.

- de

97 Club Car will not start good solenoid good battery cannot jump it what could be the problem

- de

1997 club car gas golf cart has new battery new solenoid will not turn over if I jump the solenoid still will not turn over

- de

Agregar un comentario

2 Respuestas

Solución Elegida

Leonard, If battery and solenoid known to be good, look in black box right behind the battery, take the cover off locate the 10 amp fuse and replace it if blown. If equipped with safety features like seat switch, safety neutral, etc. check/test that they are functioning properly. If all looks good there check wires and plug on ignition switch and test switch for proper function.

Hope this is of help. Good luck.

Fue útil esta respuesta?

Puntuación 3
Agregar un comentario
Respuesta Más Útil

@mezkin check to make sure your fuse (#34) has continuity and that your main switch (#30) works. Use a jumper to find out if you can "hot wire" it. If that works, replace that assembly.

Block Image

Fue útil esta respuesta?

Puntuación 3

Comentarios:

I have a G16 new coil , fuel pump cleaned carb have spark and fule but it still starts hard . So I disconnected the kill switch to coil to go around any electrical circuits. Adjusted valves to .004 with no luck ! What are the chances I sheared the key way on the flywheel? It was dieing and backfiring I have 160 compression so I'm at s loss please help

- de

Thank you. It was the 15AMP fuse. Thanks again John

- de

Yamaha g16 gas it runs for about blocks and dies . You have to let it set for awhile before it starts again like 45min can anyone help me

- de

Agregar un comentario

Añadir tu respuesta

Leonard estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 7

Ultimos 7 días: 49

Ultimos 30 días: 291

Todo El Tiempo: 36,838