Saltar al contenido principal

Lanzado el 25 de septiembre de 2015. Modelo A1688 / A1633 . La reparación de este dispositivo es similar a las generaciones anteriores, que requieren destornilladores y herramientas de palanca. Disponible como GSM o CDMA / 16 , 64 , o 128 GB / plata, oro, gris espacio, o la opcion de oro rosa.

Preguntas 2682 Ver todo

Auto Brightness setting not working after full assembly display swap

I just changed my cracked display, I ordered a full assembly kit from iFixit and followed the provided guides.

The replacement went smoothly but after fiddling around with the phone I found the next issue: Auto brightness setting is now useless, it doesn't adjust anything on the screen, everything else works perfectly, front facing camera, speaker, proximity sensor. just this one thing, so, any ideas of what could be happening?

Thanks for the advise.

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 1
2 comentarios

The ambient light sensor which is located on the front camera assembly is used to sense the amount of light it can see, depending on the level this is used to adjust auto brightness.

That part is probably damaged resulting in needing a new front camera ribbon cable assembly.

- de

Well since I ordered an assembled display and didn't mess with the camera flex is it safe to assume that iFixit send me a defective unit?

- de

Agregar un comentario

3 Respuestas

Respuesta Más Útil

Not a whole lot that could be wrong here. Most likely the flex got tore during install. The fix is a new cable, it shouldn't be too hard.

I suppose it could also be software. Restart your phone by holding power and home. After it boots, check to see if auto brightness is enabled and working. If not, its almost 100% that the flex tore.

Fue útil esta respuesta?

Puntuación 2
Agregar un comentario

The replacement screens iFixit ships are not original Apple products, and the iOS detects this (even if you swap the front camera flex with the original), and the "Auto Brightness" feature is disabled.

I had this issue with an iFixit display, and so far there is no solution. Also iFixit has not recognized this problem officialy :(

Fue útil esta respuesta?

Puntuación 1

1 comentario:

I know this thread is old. But I have to add that I replaced the pre mounted set of front facing camera and sensor cables with the original ones of the original display unit. Now it works flawlessly! But the button for auto-brightness is still missing, allthough the auto function now works!

- de

Agregar un comentario

I know this thread is old. But I have to add that I replaced the pre mounted set of front facing camera and sensor cables with the original ones of the original display unit. Now it works flawlessly! But the button for auto-brightness is still missing, allthough the auto function now works!

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Enrique Gutierrez estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 381